usb-storage 1-4.4:1.0: USB Mass Storage device detected usb 1-4.4: New USB device strings: Mfr=0, Product=0, SerialNumber=0 usb 1-4.4: New USB device found, idVendor=03fd, idProduct=0501 usb 1-4.4: not running at top speed connect to a high speed hub usb 1-4.4: No LPM exit latency info found. usb 1-4.4: new full-speed USB device number 7 using xhci_hcd LUN: removable file: (no mkdir echo /tmp/mydev > echo 1 > ln -s functions/mass_storage.ms0/ echo 'fe200000.dwc3' > configfs-gadget gadget: high-speed config #1: we connect the cable from board to Linux host machine then below are the logs: Jumper 1-2 –- Open (The shield for the USB 2.0 type-A connector (J308) can be disconncted/floating from GND by removing the jumper on header J300 pins 1-2 (default))Įdit the following file and make the following dd if=/dev/zero of=/tmp/mydev count=500 bs=1MĮcho /tmp/mydev > functions/mass_storage.ms0/lun.0/fileĮcho 1 > functions/mass_storage.ms0/lun.0/removableĥ00+0 records mount -t configfs none /sys/kernel/configįmount: mounting none on /sys/kernel/config failed: Device or resource cd mkdir cd echo '64' > echo '0x200' > echo '0x100' > echo '0x03FD' > echo '0x0501' > cat echo 'high-speed' > mkdir functions/mass_storage.ms0 Note: Need to open the J300 Jumper for device mode. Peripheral Mode USB jumper settings for Peripheral mode FAT-fs (sda1): Volume was not properly unmounted. sd 0:0:0:0: Attached SCSI removable disk sd 0:0:0:0: Write cache: enabled, read cache: enabled, doesn't support DPO or FUA scsi 0:0:0:0: Direct-Access JetFlash Transcend 32GB 1100 PQ: 0 ANSI: 6 usb-storage 1-1:1.0: USB Mass Storage device detected usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-1: New USB device found, idVendor=8564, idProduct=1000, bcdDevice=11.00 usb 1-1: new high-speed USB device number 2 using xhci-hcd Provided below test cases are proven on vck190-es1 board with 2021.1 release.Įdit the following file and make the following :~# The universal low peripheral interface (ULPI) is used to connect the controller to an external PHY operating up to 480 Mb/s. In device mode, it supports up to 12 end points. In host mode, the USB controller is compliant with the Intel XHCI specification. The core is compliant to USB 2.0 specification and supports high, full, and low-speed modes in all configurations. The USB controller can be configured as host, device, or on-the-go (OTG). Steps to add uvc-gadget test application to petalinux project The steps below use PetaLinux and assume you have some knowledge of using PetaLinux. The guide below shows you how to build USB drivers & boot the board and then run some example configurations (Host, Device, OTG mode of PS USB controller ) on Versal platform.

Amba Usb Drive